Fuel Pressure Sensor Inspection: Notes
NOTE:
- Perform the following inspection only when directed.
- The following vacuum values are indicated by relative pressure from the fuel pressure sensor.
- Remove the charge air cooler cover.
- Connect the M-MDS to the DLC-2.
- Turn the ignition switch to the ON position (Engine off).
- Select the FUEL_PRES PID on the M-MDS.
- After warming up the engine, verify that the FUEL_PRES PID is at the standard value under the following conditions.
- If not as verified, replace the fuel delivery pipe.
FUEL PRESSURE SENSOR INSPECTIONStep Condition FUEL_PRES PID 1 - Idle
- 90 s after engine is started
Approx. 3 MPa 2 - Idle
- Spill valve solenoid valve connector is disconnected
Approx. 530 kPa - After connecting the spill valve control solenoid valve connector, clear the DTC.