Section 249 (Security System And Locks System)
WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Security & Locks Location Index
- Front Outer Handle Removal/Installation
- Rear Door Release Handle Removal/Installation
- Front Inner Handle Removal/Installation
- Front Door Key Cylinder Removal/Installation
- Front Door Latch And Lock Actuator Removal/Installation
- Front Door Lock Actuator Inspection
- Rear Door Upper Latch Removal/Installation
- Rear Door Upper Latch Switch Inspection
- Rear Door Lower Latch Removal/Installation
- Rear Door Lower Latch Switch Inspection
- Front Door Lock Striker Removal/Installation
- Rear Door Lock Striker Removal/Installation
- Door Lock Switch Removal/Installation
- Door Lock Switch Inspection
- Fuel-Filler Lid Opener Removal/Installation
- Hood Latch & Release Lever Removal/Installation
- Hood Striker Removal/Installation
- Hood Latch Switch Inspection
- Keyless Control Module Removal/Installation
- Keyless Control Module Inspection
- Keyless Control Module Configuration
- Keyless Receiver Removal/Installation
- Keyless Receiver Inspection
- Transmitter Id Code Change
- Transmitter Battery Replacement
- Transmitter Battery Inspection
- Trunk Lid Latch & Opener Removal/Installation
- Trunk Lid Opener Inspection
- Trunk Key Cylinder Removal/Installation
- Trunk Key Cylinder Switch Inspection
- Trunk Lid Opener Switch Removal/Installation
- Trunk Lid Opener Switch Inspection
- Trunk Lid Striker Removal/Installation
- Trunk Lid Opener Cancel Switch Removal/Installation
- Trunk Lid Opener Cancel Switch Inspection
- Coil Removal/Installation
- Immobilizer System Component Replacement/Key Addition & Clearing
- Foreword
- No. 1 Additional Key Registration Procedure (Using 2 Valid Keys) Conditions
- No. 2 Additional Key Registration Procedure (Using WDS Or Equivalent) Conditions
- No. 3 Replacement Procedure (Clearing Previously Registered Key ID Numbers, Key Re-Registration Conditions
- No. 4 Changing The Method For Registering Additional Keys
- No. 5 Resetting Procedure For The Immobilizer System When Replacing The PCM Or Keyless Control Module Conditions
- No. 6 Security Access Procedure