LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2007 >> CX-9 V6-3.5L >> Repair and Diagnosis >> Relays and Modules >> Relays and Modules - Powertrain Management >> Relays and Modules - Computers and Control Systems >> Engine Control Module >> Service and Repair
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Engine Control Module: Service and Repair

PCM REMOVAL/INSTALLATION [MZI-3-5]

NOTE: For replace the PCM, Setup the M-MDS and perform the PCM configuration. (See PCM CONFIGURATION [MZI-3.5]. Programming and Relearning)

1. Disconnect the negative battery cable.
2. Remove the battery and battery tray.

NOTE: Only 2 PCM connectors.

3. Disconnect connectors.
4. Remove PCM and bracket as and assembly.
5. Remove PCM from bracket.
6. When replacing the PCM on the vehicles, perform the following.
- PCM parameter reset. (See IMMOBILIZER SYSTEM COMPONENT REPLACEMENT/KEY ADDITION AND CLEARING[ADVANCED KEYLESS SYSTEM].) (See IMMOBILIZER SYSTEM COMPONENT REPLACEMENT/KEY ADDITION AND CLEARING[KEYLESS ENTRY SYSTEM].)




7. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals