Using the M-MDS

Using the M-MDS

NOTE:
- PIDs for the following parts are not available on this model. Go to the appropriate part inspection.
- Main relay (See RELAY INSPECTION.)

1. Connect the M-MDS to the DLC-2.
2. Turn the ignition switch to ON position.
3. Measure the PID value.
- If PID value is not within the specification, follow the instructions in Action column.

NOTE:
- The PID/DATA MONITOR function monitors the calculated value of the input\output signals in the PCM. Therefore, an output device malfunction is not directly indicated as a malfunction of the monitored value for the output device. If a monitored value of an output device is out of specification, inspect the monitored value of the input device related to the output control.
- For input\output signals except those of the monitoring items, use a voltmeter to measure the PCM terminal voltage.
- The simulation items that are used in the ENGINE CONTROL SYSTEM OPERATION INSPECTION are as follows.
- ACCS, AIP RLY, ALTF, APV, ARPMDES, DEI, ETC-DSD, EVAPCP, FAN1, FAN2, FP, FPRR, FUELPW, GENVDSD, HTR11, HTR12, IASV, MOP POS, PACNTV, PREDELI, SSV, test, Time_DR_LR, Time_DR_RL, Time_SR_LR, Time_SR_RL