Flasher Control Module Inspection

WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.

Remove the bracket and pull it toward you.
Measure the voltage at the flasher control module terminals as indicated below.
Disconnect the flasher control module connector before inspecting for continuity at terminal F.
- If not as specified, inspect the parts listed under "Action."
- If the parts and wiring harnesses are okay but the system still does not work properly, replace the flasher control module.
Fig 1: Identifying Flasher Control Module Connector Terminals
Courtesy of MAZDA MOTORS CORP.

Fig 2: Flasher Control Module Terminal Voltage Reference List
Courtesy of MAZDA MOTORS CORP.