LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2009 >> 6 L4-2.5L >> Repair and Diagnosis >> Transmission and Drivetrain >> Manual Transmission/Transaxle >> Service and Repair >> Overhaul >> Overhaul Procedures G66M-R >> Differential Assembly >> Roll Pin Assembly Note
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Roll Pin Assembly Note

Roll Pin Assembly Note





1. Install the new roll pin as shown in the figure to hold the pinion shaft.





2. Measure the backlash by the following procedure.
1) Install the left and right drive shafts in the differential component.
2) Support the drive shaft on V-blocks as shown in the figure.
3) Measure the backlash of both pinion gears.
^ If not within the specification, replace worn and damage parts.

Differential pinion gear backlash:
0.050 - 0.150 mm (0.0020 - 0.059 in)