Auto Light Illumination Level Setting

AUTO LIGHT ILLUMINATION LEVEL SETTING

1. Connect the M-MDS (IDS) to the DLC-2.






2. After the vehicle is identified, select the following items from the initialization screen of the IDS.

- Select "Module Programming".

3. Then, select items from the screen menu in the following order.

- Select "Programmable Parameters".
- Select "Exterior Lighting".
- Select "Autolamp On Setting".

4. Select "Standard (Other)" or "Low (Other)" on the M-MDS to set the illumination level.
NOTE:
- When the M-MDS is set to Low (Other), the auto-light sensor sensitivity decreases, and the TNS and headlight illumination timing is slower.

5. Perform the procedure as indicated on the screen.

6. Perform the auto light/wiper control module configuration. Auto Light/Wiper Control Module Configuration

CAUTION:
- Perform the auto light/wiper control module configuration after updating the auto light illumination level to assure that the auto light/wiper system operates correctly.