Power Window System Initialization Procedure

POWER WINDOW SYSTEM INITIALIZATION PROCEDURE

NOTE:
- If the following operations have been performed, the initial settings are reset, and auto operation is disabled. Therefore, performing the initial setting is necessary.

- The negative battery cable is disconnected.
- Power window main switch connector is disconnected.
- Power window system power supply fuse is removed.

1. Switch the ignition ON.

2. Press the power window main switch and fully open the driver side front door glass.

3. Pull up the power window main switch to the manual-up position to fully close the driver side front door glass, and keep holding the switch up at the position for approx. 2 s.