Total Toe-in Adjustment
- Loosen the locknut of the tie-rod end.
- Remove the rack boot clamp.
- Adjust the total toe-in by rotating each tie rod (left and right) in the opposite directions by the same amount respectively.NOTE:
- Toe angle changes by approx. 6 mm {0.2 in} per one rotation of the tie rod for one wheel.
- Each tie rod has a right-hand thread. When increasing the toe-in angle, rotate the right tie rod toward the front of the vehicle and rotate the left tie rod toward the rear of the vehicle by the same amount.
- Tighten the locknut of the tie-rod end.
Tightening torque
- 79-108 N.m {8.1-11 kgf.m, 59-79 ft.lbf}
- Verify that the rack boot does not have any twisting and install the rack boot clamp.