LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2013 >> 5 Touring >> Repair and Diagnosis >> Brakes >> Traction Control >> Abs/Dynamic Stability Control System >> DSC Sensor Initialization Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DSC Sensor Initialization Procedure

WARNING:
  • If the initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, after replacing or removing the DSC HU/CM or SAS control module, make sure to perform the initialization procedure to insure proper DSC operation.
  1. Inspect the wheel alignment and the tire pressure.
    • If there is any malfunction, adjust the applicable part.
  2. Position the vehicle on level ground.
  3. Switch the ignition to off.
  4. Connect the M-MDS (IDS) to DLC-2.
  5. After the vehicle is identified, select the following items from the initial screen of the IDS.
    1. Select "Chassis".
    2. Select "ABS/DSC".
    3. Select "Sensor Initialization".
  6. Then, select an item from the screen menu.
    • "Brake Fluid Pressure Sensor"
    • "Lateral Acceleration Sensor"
    • "Yaw Rate Sensor"
  7. Perform the procedure according to the directions on the screen.
  8. Drive the vehicle.
  9. After 5 min or more  of driving, verify that the DSC system is normal.
scientia non olet · About LEMON Manuals