Fuel Pump Operation Inspection

Remove the fuel-filler cap.
Switch the ignition to ON.
Turn the fuel pump relay from off to on using the FP PID and inspect if the operation sound is heard.
- If no operation sounds is heard, proceed to next step.
Measure the voltage at wiring harness side fuel pump connector terminal B.
Specification
- B+ (Ignition at on)
- If the voltage is as specified, inspect the following:
  - Fuel pump continuity
  - Fuel pump GND
  - Wiring harness between fuel pump relay terminal E and PCM terminal 1BG
- If not as specified, inspect the following:
  - Fuel pump relay (See RELAY INSPECTION .)
  - Wiring harness connector (Battery-Fuel pump relay-Fuel pump)