Clutch Stroke Sensor Inspection
NOTE:
- The clutch stroke sensor cannot be removed as a single unit. When replacing the clutch stroke sensor, replace it together with the clutch master cylinder as a single unit.
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Verify that the clutch stroke sensor output voltage (PID: CPP) within the specification. (See ON-BOARD DIAGNOSTIC TEST
.) (See PCM INSPECTION .)
- If not as specified, replace the clutch master cylinder. (See CLUTCH MASTER CYLINDER REMOVAL/INSTALLATION [C66M-R] .)