After Repair Procedure

Switch the ignition off.
Connect the M-MDS to the DLC-2.
Switch the ignition ON (engine off).
Verify the DTC according to the directions on the M-MDS screen.
- Press the clear button on the DTC screen to clear the DTC.
Switch the ignition off for 30 s or more .
CAUTION:
- Always switch the ignition off after clearing the DTC.
- If the engine is accidentally started, disconnect the negative battery cable and reconnect it. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.5] .)
Switch the ignition ON (engine on).
Verify all accessory loads are off.
Start the engine and maintain the engine speed at 2, 800-3, 200 rpm until the cooling fan starts running (for A/F sensor and HO2S activation).
When the cooling fan starts running, idle the engine.
Maintain idle for 30 s or more after the cooling fan has stopped (for fuel learning).
Perform the DTC inspection again and verify that no DTCs are stored. (See ON-BOARD DIAGNOSTIC TEST [SKYACTIV-G 2.5] .)
Switch the ignition off.
Disconnect the M-MDS to the DLC-2.