| POSSIBLE CAUSE |
- Electrical connectors are disconnected or connected poorly
- Vacuum lines are disconnected or connected improperly.
- Poor fuel quality
- PCM DTC is stored
- Inadequate fuel pressure
- Fuel pressure sensor malfunction
- High pressure fuel pump malfunction
- Spill valve control solenoid valve control circuit malfunction (damage to driver in PCM caused by short circuit to ground system)
- Spill valve control solenoid valve (built-into high pressure fuel pump) malfunction
- Relief valve (built-into high pressure fuel pump) malfunction
- Fuel line restricted or clogged
- Fuel pump unit malfunction
- Charcoal canister malfunction
- Fuel tank vent system malfunction
WARNING:
The following troubleshooting flow chart contains the fuel system diagnosis and repair procedures. Read the following warnings before performing the fuel system services:
- Fuel vapor is hazardous. It can easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel.
- Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injury or death and damage. Fuel can also irritate skin and eyes. To prevent this, always complete "BEFORE SERVICE PRECAUTION" and "AFTER SERVICE PRECAUTION" described in this manual. (See BEFORE SERVICE PRECAUTION [SKYACTIV-G 2.5]
.) (See AFTER SERVICE PRECAUTION [SKYACTIV-G 2.5]
.)
CAUTION:
- Disconnecting/connecting the quick release connector without cleaning it may possibly cause damage to the fuel pipe and quick release connector. Always clean the quick release connector joint area before disconnecting/connecting, and make sure that it is free of foreign matter.
|