Engine Oil Solenoid Valve Control System Inspection
- Connect the M-MDS to the DLC-2.
- Perform the KOER self test. (See KOEO/KOER SELF TEST .)
- Verify that DTC P06DA:00 is not displayed. (See ON-BOARD DIAGNOSTIC TEST
.)
- If DTC P06DA:00 is displayed, perform the DTC inspection. (See DTC P06DA:00 [SKYACTIV-G 2.0, SKYACTIV-G 2.5] .)
- Inspect the engine oil pressure. (See OIL PRESSURE INSPECTION
.)
- If the engine oil pressure is not as specified, repair or replace the malfunctioning part according to the inspection results:
- Access the following PCM PIDs using the M-MDS. (See ON-BOARD DIAGNOSTIC TEST
.)
- OIL_P_SOL
- RPM
- ECT
- With the engine coolant temperature at 98 °C {208 °F}
, increase the engine speed to 4, 000 rpm or higher
, and verify that the oil pressure gauge value changes when the data monitor item OIL_P_SOL value is changed from ON to OFF.
- If the oil pressure gauge value change cannot be verified, inspect the engine oil solenoid valve. (Perform the Engine Oil Solenoid Valve Operation Inspection.)