If data monitor function of M-MDS is used

Warm up the engine and idle it.
Connect the M-MDS to the DLC-2.
Select the RPM and the FUELPW PIDs. Refer too ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.5T)] .)
Monitor both PIDs while performing the following steps:
1. Depress the accelerator pedal and increase the RPM PID to 4, 000 rpm .
2. Quickly release the accelerator pedal (brake pedal is not depressed) and verify that the FUELPW PID is 0 msec , and 2-5 msec when the RPM PID drops below 1, 200 rpm .
  - If not as specified, inspect the following:
    - ECT sensor No. 1 and related wiring harness Refer too ENGINE COOLANT TEMPERATURE (ECT) SENSOR INSPECTION [SKYACTIV-G 2.5T] .)