Charging System Warning Light
- Verify that the battery is fully charged.
- Verify that the drive belt is correct. (See DRIVE BELT INSPECTION .)
- Switch the ignition to ON, verify that the charging system warning light illuminates.
- If it does not illuminate, inspect the charging system warning light and the wiring harness.
- If the charging system warning light and the wiring harness are normal, inspect the PCM.
- Verify that the charging system warning light goes out after the engine is started.
- If the charging system warning light does not go out, perform the DTC inspection, then perform troubleshooting according to the corresponding diagnostic procedure. (See ON-BOARD DIAGNOSTIC TEST .) (See DTC TABLE .)