Engine Oil Data Reset Procedure (Without Center Display)

WARNING: This page is about a different car, the 2017 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Step	Inspection	Results	Action	Note
1	Using the M-MDS, verify the engine oil maintenance monitor function ON/OFF condition. Is the engine oil maintenance monitor function on?	Yes	Go to the next step.	If the engine oil maintenance monitor function is on, it is necessary to perform the engine oil data reset.
1		No	The engine oil data reset is unnecessary.
2	Switch the ignition ON (engine off) and switch the display using the tripmeter switch to display the odometer. CAUTION: The tripmeter and average fuel economy are reset when the following procedures are performed with tripmeter A or B displayed. Switch the ignition OFF (LOCK). Press and hold the tripmeter switch with the ignition switched off, then switch the ignition ON (engine off). Keep pressing the tripmeter switch for more than 5 s. Does the master warning light flash for a few seconds?	Yes	Engine oil data reset is completed.	The master warning light flashes for a few seconds when the engine oil data reset procedure is completed.
2		No	Perform Step 2 again.