LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2018 >> 6 Signature >> Repair and Diagnosis >> Brakes >> Traction Control >> Dynamic Stability Control System (Service Information) >> DSC Related Parts Sensor Initialization Procedure >> When Using M-MDS
April 5, 2026: LEMON Manuals is launched! Read the announcement.

When Using M-MDS

NOTE:
  • Perform initialization on the sensors shown in the following table.
Replacement Part Initialization Items
Brake Fluid Pressure Sensor Lateral Acceleration Sensor Yaw Rate Sensor Longitudinal Acceleration Sensor
DSC HU/CM Implement Implement Implement Implement
SAS control module - Implement Implement Implement
  1. Inspect the wheel alignment and the tire pressure. (See FRONT WHEEL ALIGNMENT .) (See REAR WHEEL ALIGNMENT .) (See WHEEL AND TIRE SPECIFICATION .)
    • If there is any malfunction, adjust the applicable part.
  2. Position the vehicle on level ground.
  3. Connect the M-MDS to DLC-2.
  4. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
    1. Select "Chassis".
    2. Select "ABS/DSC".
    3. Select "Sensor Initialization".
  5. Then, select an item from the screen menu.
    • "Brake fluid pressure sensor"
    • "Lateral Acceleration Sensor"
    • "Yaw Rate Sensor"
    • "Longitudinal Acceleration Sensor"
  6. Perform the procedure according to the directions on the screen.
  7. Drive the vehicle.
  8. After 5 min or more of driving, verify that the DSC system is normal.
scientia non olet · About LEMON Manuals