LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2018 >> 6 Signature >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Systems >> Fuse Block Removal/Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuse Block Removal/Installation: Removal

  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the following parts:
    1. Front scuff plate (LH) (See FRONT SCUFF PLATE REMOVAL/INSTALLATION .)
    2. Front side trim (LH) (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
    3. LF control unit (with advanced keyless entry system) (See LF CONTROL UNIT REMOVAL/INSTALLATION .)
  3. Remove all the fuses.
  4. Cut the band shown in the figure below.
    Fig 1: Fuse Block, Clip, Tab And Bolt
    G12237494Courtesy of MAZDA MOTORS CORP.
  5. Remove the bolt.
  6. Remove the fuse block clip from the body.
  7. Disconnect the connector.
    Fig 2: Fuse Block And Connector
    G12237495Courtesy of MAZDA MOTORS CORP.
  8. Set the removed fuse block aside so that it does not scratch the vehicle and parts.
scientia non olet · About LEMON Manuals