Function Inspection
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Display the PIDs MAP_V and MAP. (See ON-BOARD DIAGNOSTIC TEST .) (See PCM INSPECTION .)
- Compare the voltage and manifold absolute pressure indications for the PIDs MAP_V and MAP with the standard in the table indicated below.
- If they do not match the standard, perform the voltage inspection. (See Voltage Inspection .)
Standard
VOLTAGE SPECIFICATION
| MAP_V | MAP | Remarks |
|---|---|---|
| V | kPa {kgf/cm2 , psi} | |
| Approx. 4.12 | 101 {1.03, 14.6} | Ignition switched ON (engine off) |
| Approx. 1.90 | 33 {0.34, 4.8} | Idle (after warm up) |
| Approx. 1.23 | 26 {0.27, 3.8} | Racing (Engine speed: 2, 000 rpm) |