Rear Housing Installation Note

NOTE:

After applying silicone sealant (TB1217D or equivalent), install the rear housing within 10 min. and then tighten all bolts within 5 min.

Apply silicone sealant (TB1217D or equivalent) to the areas shown in the figure.

Fig 1: Applying Silicone Sealant (TB1217D) To High Pressure Fuel Pump
Courtesy of MAZDA MOTORS CORP.

Thickness

3.0-7.0 mm {0.12-0.27 in}
Install the rear housing.
Tightening torque

20-26 N.m {2.1-2.6 kgf.m, 15-19 ft.lbf}
Install the ECT sensor No. 1. (See Engine Coolant Temperature (ECT) Sensor Removal/Installation .)
Install the exhaust CMP sensor. (See Camshaft Position (CMP) Sensor Removal/Installation .)
Install the vacuum pump. (See VACUUM PUMP REMOVAL/INSTALLATION .)
Connect the turbocharger air outlet pipe to the dynamic pressure turbo. (See Intake-Air System Removal/Installation .)
Install the battery tray. (See BATTERY REMOVAL/INSTALLATION .)