Power Window System Initialization Procedure
NOTE:
- If the following operations have been performed, the initial settings are reset, and auto operation is disabled. Therefore, performing the initial setting is necessary.
- Replace the door-electrical supply unit
- Manual open/close operation is performed 10 times using power window main switch or power window sub switch without fully closing door glass.
- Switch the ignition ON (engine on or off).
- Operate the power window main switch or power window sub switch to fully open the door glass for which auto operation is disabled.
- Pull up the power window main switch or power window sub switch to the top position to fully close the door glass, and keep holding the switch up at the position for approx. 2 s or more.