Instrument Cluster Configuration (Using Read/Write Function)
NOTE:
- When performing configuration, it is necessary to read the vehicle specification information from the instrument cluster before replacing it. Connect the M-MDS to the vehicle and perform vehicle identification before removing the instrument cluster. The vehicle specification information is temporarily stored in the M-MDS.
- Connect the M-MDS (IDS) to DLC-2.
- After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- "Module programming"
- Then, select the following from the screen menu.
- "Programmable Module Installation"
- "IC"
- Perform the configuration following the instructions on the screen.CAUTION:
- When the configuration is performed, CAN communication between the instrument cluster and control module connected to the CAN line is cut temporarily, and communication error DTCs may be detected. After performing the configuration, verify the DTCs for the control module connected to the CAN line and clear it if any DTC is detected.
- Verify the DTCs for all of the control modules connected to the CAN line.
- If any DTC is stored, clear it.
- If the DTC is cleared, finish the procedure because the configuration has been completed normally.
- If the DTC remains, perform troubleshooting according to the DTC.