Verify Fuse Block Replacement
- Temporarily connect the negative battery terminal to verify that the related wiring harness is not heated.
- Switch the ignition ON (engine off).
- Verify that the fuse is not blown and the related wiring harness is not heated.
- Perform the initial settings for the following systems:
- Verify DTCs using the M-MDS.
- If a DTC is displayed, repair the malfunctioning part according to the corresponding DTC inspection.
- After completion of repairs, clear all DTCs stored in the module.
- If there is no malfunction in Step 1, 3, and 5, start the engine and maintain the idle status.
- Operate all the switches of the interior/exterior lights of the vehicle and verify that all the light bulbs illuminate and flash.
- Operate the audio, climate control, wiper switch, and selector lever (ATX) and verify that they operate correctly.
- Shift the selector lever to the P position, race the engine at approx. 3, 000 rpm from engine idling, and verify that there is no malfunction. (ATX)
- Perform a road test and verify that low speed, acceleration, shift-up, and shift-down conditions are normal. (ATX)