Engine oil data reset procedure
ENGINE OIL DATA RESET DIAGNOSTIC PROCEDURE
| STEP |
INSPECTION |
RESULTS |
ACTION |
Note |
| 1 |
- Using the M-MDS, verify the engine oil maintenance monitor function ON/OFF condition.
- Is the engine oil maintenance monitor function on?
|
Yes |
Go to the next step. |
If the engine oil maintenance monitor function is on, it is necessary to perform the engine oil data reset. |
| No |
The engine oil data reset is unnecessary. |
| 2 |
- Switch the ignition ON (engine off) and switch the display using the tripmeter switch to display the odometer.
CAUTION:
- The tripmeter and average fuel economy are reset when the following procedures are performed with tripmeter A or B displayed.
- Switch the ignition OFF (LOCK).
- Press and hold the tripmeter switch with the ignition switched off, then switch the ignition ON (engine off).
- Keep pressing the tripmeter switch for more than 5 s.
- Does the master warning light flash for a few seconds?
|
Yes |
Engine oil data reset is completed. |
The master warning light flashes for a few seconds when the engine oil data reset procedure is completed. |
| No |
Perform Step 2 again. |