Section 73 (On-Board Diagnostic - Blind Spot Monitoring Control Module)
WARNING: This page is about a different car, the 2016 Mazda CX-3. However, it is still accessible from the selected car via links, so may be relevant.
- On-Board Diagnostic Wiring Diagram
- Foreword
- DTC Test
- Clearing DTC
- DTC Table
- DTC B11CB-11: Blind Spot Monitoring (BSM) System Is Stopped
- DTC B11CB-15: Blind Spot Monitoring (BSM) Warning Light (RH) Circuit Malfunction
- DTC B11D3-11: Blind Spot Monitoring (BSM) Warning Light (LH) Circuit Malfunction
- DTC B11D3-15: Blind Spot Monitoring Warning Light Circuit Malfunction
- DTC B11F2-23: Blind Spot Monitoring (BSM) Switch Circuit Malfunction
- DTC U0001-88; U0100-00; U0121-00; U0155-00; U0214-00: Unit Communication Error (Ms-Can)
- DTC U0028-87: Blind Spot Monitoring (BSM) Control Module (LH) And (RH) Communication Error
- DTC U0401-68: Error Signal Received From Pcm
- DTC U0415-68: Error Signal Received From DSC HU/Cm
- DTC U0423-68: Error Signal Received From Instrument Cluster
- DTC U0515-68: Error Signal Received From Start Stop Unit
- DTC U1A4B-16: Blind Spot Monitoring (BSM) Control Module (RH) Low Power Supply Voltage Input
- DTC U1A4B-17: Blind Spot Monitoring (BSM) Control Module (RH) High Power Supply Voltage Input
- DTC U1A4B-43; U1A4B-44; U1A4B-45; U1A4B-46; U1A4B-47; U1A4B-48; U1A4B-49; U1A4B-96: Blind Spot Monitoring (BSM) Control Module (RH) Malfunction
- DTC U1A4B-54: Radar Aiming Is Not Performed
- DTC U1A4B-97: Radar Sensor Sensitivity Temporarily Decreases
- DTC U2300-54: Configuration Data Not Received From Instrument Cluster
- DTC U2300-55: Instrument Cluster Configuration Not Implemented
- DTC U2300-56: Configuration Data Unmatched With Instrument Cluster
- DTC U2300-64: Instrument Cluster Configuration Error
- DTC U3000-42; U3000-43; U3000-44; U3000-45; U3000-46; U3000-47; U3000-48; U3000-49; U3000-96: Blind Spot Monitoring (BSM) Control Module (LH) Malfunction
- DTC U3000-4B: When Replacing A Blind Spot Monitoring (BSM) Control Module (RH) Having Any Of The Following Part Numbers, It Is Necessary To Replace The Blind Spot Monitoring (BSM) Control Module (LH) At The Same Time To Perform The Configuration Normally.
- DTC U3000-54: Radar Aiming Is Not Performed Or Radar Sensor Axis Is Deviated (Blind Spot Monitoring (BSM) Control Module (LH)
- DTC U3000-97: Radar Sensor Sensitivity Temporarily Decreases Depending On Various External And Environmental Factors (Blind Spot Monitoring (BSM) Control Module (LH)
- DTC U3003-16: Blind Spot Monitoring (BSM) Control Module (LH) Low Power Supply Voltage Input
- DTC U3003-17: Blind Spot Monitoring (BSM) Control Module (LH) High Power Supply Voltage Input
- PID Data Monitor Test
- PID Data Monitor Table
- Active Command Modes Inspection
- Active Command Modes Table