Rear Power Window Regulator Removal/Installation

Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
Remove the following parts:
1. Power window subswitch (rear-side) (See POWER WINDOW SUBSWITCH REMOVAL/INSTALLATION .)
2. Rear door trim (See REAR DOOR TRIM REMOVAL/INSTALLATION .)
3. Rear power window motor (See REAR POWER WINDOW MOTOR REMOVAL/INSTALLATION .)
4. Rear door glass (See REAR DOOR GLASS REMOVAL/INSTALLATION .)
Remove the nuts.

Fig 1: Rear Power Window Regulator Nuts With Torque Specification
Courtesy of MAZDA MOTORS CORP.
Insert your hand through the service hole and support the drum housing.

Courtesy of MAZDA MOTORS CORP.
Move the clip tabs in the direction of arrow (1) shown in the figure to detach the tabs, and move the clip in the direction of arrow (2) to remove.
Remove the rear power window regulator through the service hole.
CAUTION:
- When removing the rear power window regulator, the rear power window regulator may contact the service hole, and the coating film of the rear door inner panel and the rear power window regulator could be damaged. Remove the rear power window regulator while verifying that the rear power window regulator and the service hole do not contact each other.
Courtesy of MAZDA MOTORS CORP.
Install in the reverse order of removal.