Boost Pressure Sensor/Boost Air Temperature Sensor Removal/Installation

WARNING: This page is about a different car, the 2017 Mazda CX-9. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

The boost pressure sensor and boost air temperature sensor cannot be removed as a single unit. When replacing the boost pressure sensor or boost air temperature sensor, replace the boost pressure sensor/boost air temperature sensor.

Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Remove the front bumper. (See FRONT BUMPER REMOVAL .) (See FRONT BUMPER INSTALLATION .)
Remove the fastener.

Fig 1: Boost Pressure Sensor/Boost Air Temperature Sensor, Fastener And Charge Air Cooler Duct (RH)
Courtesy of MAZDA MOTORS CORP.
Remove the charge air cooler duct (RH).
Disconnect the boost pressure sensor/boost air temperature sensor connector.

Fig 2: Boost Pressure Sensor/Boost Air Temperature Sensor Connector, Short Cord Connector And Clips
Courtesy of MAZDA MOTORS CORP.
Remove the charge air cooler. (See CHARGE AIR COOLER REMOVAL/INSTALLATION .)
Remove the screw.

Fig 3: Boost Pressure Sensor/Boost Air Temperature Sensor And Screw With Torque Specification
Courtesy of MAZDA MOTORS CORP.
Remove the boost pressure sensor/boost air temperature sensor.
Install in the reverse order of removal.