Function Inspection
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Display the PIDs MAP_V and MAP. (See ON-BOARD DIAGNOSTIC TEST [PCM (SKYACTIV-G 2.0)]
.)
(See PCM INSPECTION .)
- Compare the voltage and manifold absolute pressure indications for the PIDs MAP_V and MAP with the standard in the table indicated below.
- If they do not match the standard, replace the PCM. (See PCM REMOVAL/INSTALLATION .)
- If they match the standard, perform the voltage inspection. (See VOLTAGE INSPECTION .)
Standard
| MAP_V | MAP | Remarks |
|---|---|---|
| V | kPa {kgf/cm2 , psi} | |
| Approx. 4.04 | 100 {1.02, 14.5} | Ignition switched ON (engine off) |
| Approx. 1.40 | 35 {0.36, 5.1} | Idle (after warm up) |
| Approx. 1.01 | 26 {0.27, 3.8} | Racing (Engine speed: 2, 000 RPM) |