On-demand Self-test: Notes
- Connect the M-MDS to the DLC-2.
- When performing the body control module (BCM) self-test, verify that the vehicle is under the following conditions.
When performing the KOEO On-Demand self-test for Door Lock System:
- All doors, hood, trunk (4SD)/liftgate (5HB) are closed
- All doors are unlocked
When performing the KOEO On-Demand self-test for Lighting Systems:
- Hazard warning switch is off
- Light switch is off
- Rear window defogger switch is off
- Selector lever is in position other than R (ATX)/shift lever is in position other than reverse (MTX)
- Switch the ignition ON (engine off or on).
- Perform the vehicle identification.
- Perform the following procedure using the M-MDS.
- Press [Start] for the vehicle identification.
- Press the [Toolbox] tab.
- Press the [Diagnosis] icon.
- Press [On-demand self-test].
- Press the applicable [M-MDS display name] from the module table. (See Module table .)
- Press [Run] for the applicable [Self-test type] from the module table. (See Module table .)
- Verify DTCs following the instructions on the screen.
- If a DTC is displayed, repair the malfunctioning location according to the applicable DTC troubleshooting.