Seat Position Initial Learning

WARNING: This page is about a different car, the 2021 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Connect the M-MDS to the DLC-2.
Switch the main power ON (READY off).
Activate the M-MDS and perform the following procedure.
1. Press [Start] to start the vehicle identification.
2. Press the [Toolbox] tab.
3. Press the [Work Support] icon.
4. Press [SEATS].
5. Press [Run] for [Calibrating Driving Position].
6. Confirm the Calibrating Driving Position procedure from Step (7) to Step (12), and press [Next].
7. Verify that the main power is switched ON (READY off) and press [Next].
  NOTE:
  - When operating the power seat switch, hold the switch for 1 s or more after the seat position movement stops.
8. Operate the power seat switch and move the seat position to the following conditions.
  - Slide rear end
  - Tilt lower end
  - Lift lower end
9. When Step (8) is completed, press [Next].
  NOTE:
  - When operating the power seat switch, hold the switch for 1 s or more after the seat position movement stops.
10. Operate the power seat switch and move the seat position to the following conditions.
  - Slide front end
  - Tilt upper end
  - Lift upper end
11. When Step (10) is completed, press [Next].
12. Press [Next] to complete [Calibrating Driving Position].