Operation After Replacing Front Power Window Regulator
CAUTION:
- If the following symptoms occur after the front power window regulator is replaced, perform the [OPERATION AFTER REPLACING FRONT POWER WINDOW REGULATOR].
- During a front door glass close operation, the front door glass reverses at the fully-closed position and the front door glass cannot be fully closed.
- Even if a front door glass close operation is performed, the front door glass does not rise to the fully-closed position.
- The auto reverse pinch protection function does not operate near the fully-closed position.
- Fully open the front door glass.
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(US)] .)
- Remove the following parts:
- Inner garnish (See INNER GARNISH REMOVAL/INSTALLATION .)
- Power window main switch (to remove from driver's side) (See POWER WINDOW MAIN SWITCH REMOVAL/INSTALLATION .)
- Power window subswitch (front) (to remove from passenger's side) (See POWER WINDOW SUBSWITCH REMOVAL/INSTALLATION .)
- Front door trim (See FRONT DOOR TRIM REMOVAL/INSTALLATION [(US)] .)
- Disconnect the connector.
- Connect the connector of the power window main switch or the power window subswitch (front).
- Connect the negative battery terminal.
- Switch the ignition ON (engine off or on).
- Operate the power window main switch or the power window subswitch (front) and perform the close operation of the front door glass for approx. 2 s.
- Clear the DTC. (See CLEARING DTC .)
- Perform the power window system initialization procedure. (See POWER WINDOW SYSTEM INITIALIZATION PROCEDURE .)
- Verify that the front door glass open/close function is operating correctly.