Operation After Replacing Rear Power Window Regulator
CAUTION:
- If the following symptoms occur after the rear power window regulator is replaced, perform the [OPERATION AFTER REPLACING REAR POWER WINDOW REGULATOR].
- During a rear door glass close operation, the rear door glass reverses at the fully-closed position and the rear door glass cannot be fully closed.
- Even if a rear door glass close operation is performed, the rear door glass does not rise to the fully-closed position.
- The auto reverse pinch protection function does not operate near the fully-closed position.
- Perform the rear door glass preparation. (See REAR DOOR GLASS REMOVAL/INSTALLATION .)
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(US)] .)
- Remove the following parts:
- Power window subswitch (rear) (See POWER WINDOW SUBSWITCH REMOVAL/INSTALLATION .)
- Rear door trim (See REAR DOOR TRIM REMOVAL/INSTALLATION .)
- Disconnect the connector.
- Connect the connector of the power window subswitch.
- Connect the negative battery terminal.
- Switch the ignition ON (engine off or on).
- Operate the power window subswitch (rear) and perform the close operation of the rear door glass for approx. 2 s.
- Clear the DTC. (See CLEARING DTC .)
- Perform the power window system initialization procedure. (See POWER WINDOW SYSTEM INITIALIZATION PROCEDURE .)
- Verify that the rear door glass open/close function is operating correctly.