DTC C0062-76: SAS Control Module System [DSC HU/Cm]

DTC C0062:76 (DSC HU/CM) DETECTION CONDITION AND POSSIBLE CAUSE

DTC	C0062:76	SAS control module system
DETECTION CONDITION		Error is detected in communication with SAS control module by CAN communication.
FAIL-SAFE FUNCTION		Refer to "DTC Table" and "Fail-safe Function Malfunction Contents". (See DTC TABLE [DSC HU/CM] .)
POSSIBLE CAUSE		Poor SAS control module installation Low-G sensor malfunction in SAS control module DSC HU/CM malfunction
SYSTEM WIRING DIAGRAM		Not applicable

DTC C0062:76 (DSC HU/CM) DIAGNOSTIC PROCEDURE

Step	Inspection	Results	Action
1	VERIFY IF SAS CONTROL MODULE IS CORRECTLY INSTALLED Verify the SAS control module installation condition. (See SAS CONTROL MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC.] .) Is the installation condition normal?	Yes	Go to the next step.
1		No	Install the SAS control module correctly, then go to the next step.
2	INSPECT SAS CONTROL MODULE MALFUNCTION Switch the ignition to off. Using the M-MDS, perform the DTC inspection for the SAS control module. (See DTC TABLE [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC.)] .) Are any DTCs detected?	Yes	Go to applicable DTC inspection. (See DTC TABLE [SAS CONTROL MODULE (TWO-STEP DEPLOYMENT CONTROL SYSTEM - US/CANADA SPEC.)] .)
2		No	Go to the next step.
3	PERFORM DSC RELATED PARTS SENSOR INITIALIZATION Perform the DSC related parts sensor initialization for the PCM using the M-MDS. (See DSC RELATED PARTS SENSOR INITIALIZATION PROCEDURE .) Is the DSC sensor initialization completed normally?	Yes	Go to the next step.
3		No	Replace the DSC HU/CM, then go to the next step. (See DSC HU/CM REMOVAL/INSTALLATION [SKYACTIV-G 2.5 (VIN M)] .) (See DSC HU/CM REMOVAL/INSTALLATION [VIN Y] .)
4	VERIFY THAT THE SAME DTC IS NOT PRESENT Using the M-MDS, clear the DTC from the DSC HU/CM. (See CLEARING DTC [DSC HU/CM] .) Using the M-MDS, perform the DSC HU/CM DTC inspection. (See DTC INSPECTION [DSC HU/CM] .) Are the same DTCs present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the DSC HU/CM, then go to the next step. (See DSC HU/CM REMOVAL/INSTALLATION [SKYACTIV-G 2.5 (VIN M)] .) (See DSC HU/CM REMOVAL/INSTALLATION [VIN Y] .)
4		No	Go to the next step.
5	VERIFY THAT NO OTHER DTCS ARE PRESENT Are any other DTCs output?	Yes	Go to the applicable DTC inspection. (See DTC TABLE [DSC HU/CM] .)
5		No	DTC troubleshooting completed.