Function inspection

Connect the M-MDS to the DLC-2.
Switch the ignition ON (engine off).
Display the PCM PID [BOOST_AIR_TEMP] and [BOOST_AIR_TEMP_VOLT]. (Refer to [PID/DATA MONITOR INSPECTION ] in the troubleshooting information.) (Refer to [PID/DATA MONITOR TABLE [PCM (SKYACTIV-G 2.5T)] ] in the troubleshooting information.)

Compare the voltage and temperature indications for the PIDs [BOOST_AIR_TEMP_VOLT] and [BOOST_AIR_TEMP] with the standard in the table indicated below.

If they do not match the standard, perform the resistance inspection. (See RESISTANCE INSPECTION .)

BOOST AIR TEMPERATURE SENSOR SPECIFICATIONS (STANDARD)

PID [BOOST_AIR_TEMP_VOLT]	PID [BOOST_AIR_TEMP]
V	°C {°F}
Approx. 3.71	20 {68}
Approx. 3.19	40 {104}
Approx. 3.27	60 {140}