Function Inspection
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Display the PCM PID [BOOST_PRES_ACT] and [BOOST_PRES_ACT_VOLT]. (Refer to [PID/DATA MONITOR INSPECTION ] in the troubleshooting information.) (Refer to [PID/DATA MONITOR TABLE [PCM (SKYACTIV-G 2.5T)] ] in the troubleshooting information.)
- Compare the voltage and boost pressure indications for the PIDs [BOOST_PRES_ACT_VOLT] and [BOOST_PRES_ACT] with the standard in the table indicated below.
- If they do not match the standard, perform the voltage inspection. (See VOLTAGE INSPECTION .)BOOST PRESSURE SENSOR SPECIFICATIONS (STANDARD)
BOOST_PRES_ACT_VOLT BOOST_PRES_ACT Remarks V kPa {kgf/cm2 , psi} Approx. 1.18 101 {1.03, 14.6} Ignition switched ON (engine off) Approx. 0.27 33 {0.34, 4.8} Idle (after warm up) Approx. 0.18 26 {0.27, 3.8} Racing (Engine speed: 2, 000 rpm)
- If they do not match the standard, perform the voltage inspection. (See VOLTAGE INSPECTION .)