Function Inspection
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Display the PCM PID [FUEL_PRES]. (Refer to [PID/DATA MONITOR INSPECTION ] in the troubleshooting information.) (Refer to [PID/DATA MONITOR TABLE [PCM (SKYACTIV-G 2.5T)] ] in the troubleshooting information.)
- Compare the voltage and fuel pressure indications for the PID [FUEL_PRES] with the standard in the table indicated below.
- If they do not match the standard, perform the voltage inspection. (See VOLTAGE INSPECTION .)HIGH FUEL PRESSURE SENSOR SPECIFICATIONS (STANDARD)
FUEL_PRES Remarks V MPa {kgf/cm2 , psi} Approx. 0.83-0.9 2.75-3.25 {28.1-33.1, 399-471} Idle (after warm up)
- If they do not match the standard, perform the voltage inspection. (See VOLTAGE INSPECTION .)