Function Inspection

Connect the M-MDS to the DLC-2.
Switch the ignition ON (engine off).
Display the PCM PIDs [MAP_VOLT] and [MAP]. (Refer to [PID/DATA MONITOR INSPECTION ] in the troubleshooting information.) (Refer to [PID/DATA MONITOR TABLE [PCM (SKYACTIV-G 2.5T)] ] in the troubleshooting information.)

Compare the voltage and manifold absolute pressure indications for the PIDs [MAP_VOLT] and [MAP] with the standard in the table indicated below.

If they do not match the standard, perform the voltage inspection. (See VOLTAGE INSPECTION .)

MANIFOLD ABSOLUTE PRESSURE SENSOR SPECIFICATIONS (STANDARD)

MAP_VOLT	MAP	Remarks
V	kPa {kgf/cm² , psi}	Remarks
Approx. 1.73	101 {1.03, 14.6}	Ignition switched ON (engine off)
Approx. 0.74	33 {0.34, 4.8}	Idle (after warm up)
Approx. 0.63	26 {0.27, 3.8}	Racing (Engine speed: 2, 000 rpm)