Function inspection
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Display the PID ECT and ECT2_V. (See ON-BOARD DIAGNOSTIC TEST [PCM (VIN L (WITHOUT CYLINDER DEACTIVATION))] .) (See PCM INSPECTION [VIN L (WITHOUT CYLINDER DEACTIVATION)] .)
- Compare the voltage indications for PID ECT2_V and the temperature indications for PID ECT with the standards in the table indicated below.
- If they do not match the standard, replace the PCM. (See PCM REMOVAL/INSTALLATION [VIN M (WITH CYLINDER DEACTIVATION)] .)
- If they match the standard, perform the resistance inspection. (See Resistance inspection .)