Function Inspection
- Connect the M-MDS to the DLC-2.
- Switch the ignition ON (engine off).
- Display the PID INLET_PRES. (See ON-BOARD DIAGNOSTIC TEST [PCM(VIN Y)] .) (See PCM INSPECTION .)
- Compare the voltage and boost pressure indications for the PID INLET_PRES with the standard in the table indicated below.
- If they do not match the standard, perform the voltage inspection. (See Voltage Inspection .)
STANDARD SPECIFICATION
| INLET_PRES | Remarks | |
|---|---|---|
| V | kPa {kgf/cm2 , psi} | |
| Approx. 1.83 | 107 {1.09, 15.5} | Ignition switched ON (engine off) |
| Approx. 1.95 | 115 {1.17, 16.7} | Idle (after warm up) |
| Approx. 1.98 | 117 {1.19, 17.0} | Racing (Engine speed: 2, 000 rpm) |