LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mercedes Benz >> 1990 >> 560SEC >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Fuel System >> Lambda Control (CALIFORNIA Models) Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Lambda Control (CALIFORNIA Models) Test

  1. Start and warm engine to normal operating temperature. Connect On-Off Ratio Tester (KDJE-P 600) to diagnostic socket located on left fenderwell. Press IR 100% button on tester. Start engine.
  2. Press push button in diagnostic test connector for 2-4 seconds. LED should blink once, indicating that no codes are stored in memory. Press push button again for 2-4 seconds, this will program CIS-E control unit to read the on-off ratio. LED should stay on.
  3. Observe on-off ratio at 2500 RPM. Record average reading. Compare this value with idle speed reading. The average idle speed value should not vary from the average value at 2500 RPM by more than +/-10. Adjust on-off ratio if it is not within specifications.
scientia non olet · About LEMON Manuals