LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mercedes Benz >> 1993 >> 300D >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> 5-Cylinder >> Idle Speed Control
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Idle Speed Control

  1. Connect a tachometer to diagnostic connector terminal No. 2 (engine RPM signal) and terminal No. 1 (ground). Diagnostic connector is located in right rear corner of engine compartment. With engine idling and engine coolant temperature approximately 176°F (80°C), engine speed should be 660-710 RPM. If engine speed is 660-710 RPM, go to next step. If engine speed is not 660-710 RPM, go to step 3).
  2. Disconnect idle speed control actuator electrical connector. Engine speed should drop to 590-630 RPM. If engine speed drops within specification, idle speed control system is functioning properly. If engine speed does not drop within specification, adjust engine speed at injection pump. See ADJUSTMENTS article in the ENGINE PERFORMANCE Section.
  3. Repair or replace idle speed control actuator, injection pump, and engine speed sensor. Check Electronic Diesel System (EDS) control unit connector. Repair as necessary.
scientia non olet · About LEMON Manuals