DTC Description

Fault Memory & Actuation Of MIL - No activation of MIL.
Frequency Of Testing - Continuous.
Checked Signal Or Status - Signal line and signal of oil pressure sensor.
Limit Values - Signal voltage must be 0.4-4.6 volts. If voltage is different, circuit is shorted or open. With engine speed up to 600 RPM, oil pressure must be less than 5 bar (approximately 4.4 volts). From 1500 RPM, oil pressure must be more than 1.5 bar (approximately 1.6 volts).
Duration Of Test - Approximately one second.

NOTE: If oil pressure sensor detects a constant level of oil pressure, it is not determined to be defective. This does not limit the cylinder cut-out system.

Further diagnostic information is not available.