LH ENGINE 120 (description only)
LH Engine 120
| DTC | Description Only - No Test Available |
|---|---|
| 1 | No malfunction in system |
| 10 | CTP (idle) recognition from EA/CC/ISC control module (N4/1), short circuit (DTC10 can be displayed even if no fault is present.) |
| 11 | AIR pump system, open/short circuit (DTC11 can be displayed even if no fault is present.) |
| 12 | Burn-off control for hotwire MAF sensor, open/short circuit |
| 13 | Left or right IAT sensor(B17/5 or B17/6), open/short circuit |
| 14 | Not used |
| 15 | Not used |
| 16 | Left or right EGR switchover valve (Y27/2 or Y27/3), open/short circuit (DTC16can be displayed even if no fault is present.) |
| 17 | No CAN data transmission with EA/CC/ISC control module (N4/1) (DTC17can be displayed even if no fault is present.) |
| 18 | No CAN data with left or right DI control module (N1/4 or N1/5) |
| 19 | No CAN data transmission between left and right LH-SFI control module |
| 2 | Left or right ECT sensor(B11/9 or B11/10) sensor circuit 1, open/short circuit |
| 20 | No CAN data transmission from left or right LH-SFI control module (N3/2 or N3/3) |
| 21 | Left or right O2S 1 (before TWC) (G3/3 or G3/4), open/short circuit |
| 22 | O2S 1 heater, open/short-circuit |
| 23 | Left or right purge control valve (Y58/2 or Y58/3), open/short circuit |
| 24 | Not used |
| 25 | Left or right adjustable camshaft timing solenoid (Y49/1 or Y49/2), open/short circuit |
| 26 | Upshift delay switch over valve (Y3/3), open/short circuit |
| 27 | Left or right injectors (Y63or Y64), open/short circuit |
| 28 | Left or right LH-SFI control module coding, open circuit |
| 3 | Left or right ECT sensor(B11/9 or B11/10) sensor circuit 2, open/short circuit |
| 4 | Voltage at left or right hot wire MAF sensor (B2/3 or B2/4) insufficient or too high, or open circuit in ground wire at hot wire MAF sensor (DTC4 can be displayed even if no fault is present.) |
| 5 | Not used |
| 6 | Not used |
| 7 | TN-signal (RPM signal) incorrect or open/short circuit |
| 8 | Left or right CMP sensor(L5/2 or L5/3) signal, open/short circuit |
| 9 | Starter signal (circuit 50) missing, open/short circuit |