Check & Adjust Camber & Caster At Front Axle: Notes
CAUTION:
This procedure requires tensioning and untensioning the front coil springs. Risk of pinching and jamming body parts when working on pre-loaded components. When loosening or removing components that are under significant load, there is a risk of serious injury if non-approved clamping devices are used. When conducting repair work on springs, spring bodies, spring-type actuators and other components that are under tension use approved clamping devices only. Use only approved clamping devices. Shield off hazard area if necessary. Inspect special tools for damage and proper operation (visual inspection). Wear eye protection and protective gloves.
NOTE:
For tool identification, see Figure
under SPECIAL TOOLS.
NOTE:
For torque specifications and values, see TORQUE SPECIFICATIONS
table.
NOTE:
During procedures number(s) and letter(s) in parentheses correspond to number(s) and letter(s) inside the illustration(s). The word arrow(s) in parentheses is used to point out specific components or movement.