Throttle Position Switch (1.3L)
- Ensure idle speed and ignition timing are adjusted to specification. Stop engine. Disconnect negative battery cable.CAUTION: DO NOT tamper with throttle stop screw at throttle lever. Doing so may result in damage to the throttle body.
- Unplug TPS connector at throttle body. Insert appropriate feeler gauge between throttle stop screw and stop lever. Check for continuity between specified terminals on TPS connector. See ON-VEHICLE ADJUSTMENTS article and TPS CONTINUITY table.
TPS CONTINUITY
| Test Condition (1) | Cont. Between IDL-TL | Cont. Between PSW-TL | ||
|---|---|---|---|---|
| .02" (.5 mm) | Yes | No | ||
| .03" (.7 mm) | No | No | ||
| Wide Open Throttle | No | Yes | ||
|
||||