Electronic Vehicle Info Center: Installation
WARNING: This page is about a different car, the 2004 Dodge Pickup and 2004 Dodge Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Position the EVIC module in the overhead console.
- Install the screws holding the EVIC module in the overhead console.
- Connect the EVIC module electrical connector.
- Install the overhead console on the headliner (Refer to INSTALLATION ).
- Connect the battery negative cable.
- Check EVIC module function.
NOTE:
If a new EVIC module has been installed, the compass will have to be calibrated and the variance set. Refer to COMPASS VARIATION ADJUSTMENT
and COMPASS CALIBRATION
for the procedures.