Pinpoint Test D - Right Window Inoperative
- With ignition off, disconnect master window switch connector located on left hand front door trim panel. Measure resistance between wire terminals on master window switch. See the MASTER WINDOW SWITCH RESISTANCES table. If master window switch is okay, go to next step. If NOT, replace master window switch.
- With ignition off, disconnect inoperative window regulator and motor connector. Using a jumper wire, connect one terminal of window regulator and motor to battery positive terminal. Using a jumper wire, connect other terminal of window regulator and motor to negative battery terminal. Reverse jumper wires on window regulator and motor.
- Window will move in one direction (down or up) when battery voltage is applied. When battery voltage is reversed, window regulator and motor operated window in opposite direction. If right window regulator and motor does not operate as specified, replace right window regulator and motor. If okay, go to next step.
- With ignition off, disconnect right window switch connector. With ignition on, measure battery voltage of Orange/Black wire of right window switch connector. See Fig 1 . If battery voltage is greater than 10 volts, go to next step. If NOT, repair Orange/Black wire.
- With ignition off, remove right window switch. Refer to WINDOW SWITCH
under REMOVAL & INSTALLATION. Leave electrical connector connected. With ignition on, check for battery voltage at right window switch while moving right window switch to UP, NORMAL and DOWN position. See RIGHT WINDOW SWITCH VOLTAGE
table. If right window switch does not operate as specified, replace right window switch. If okay, go to next step.RIGHT WINDOW SWITCH VOLTAGE
Position Wire Color Voltage UP Blue/Yellow Less Than 1 " Blue/Orange Greater Than 10 NORMAL Blue/Yellow Less Than 1 " Blue/Orange Less Than 1 DOWN Blue/Yellow Greater Than 10 " Blue/Orange Less Than 1 - With ignition off, disconnect right window switch and right window regulator and motor connector. Measure resistance of Light Green/Blue and Orange/Black wires between master window switch and right window switch connector. Measure resistance of Light Green/Black and Orange/Blue wires between master window switch and ground.
- If resistances are less than 5 ohms between right window switch and right window regulator and motor connector, and greater than 10,000 ohms between master window switch and ground, service wire(s) between right window switch and right window regulator and motor. If NOT, repair Light Green/Black and Orange Blue wires.