Equipment Hookup
NOTE:
Some tests instruct the hookup of equipment to the fuse panel diagnostic connector. See Fig 2. The diagnostic connector provides access to non-OBD-II functions. This connector is not generally used during normal engine diagnostic procedures.
NOTE:
After performing equipment hookup, follow quick test procedure. See QUICK TEST .
- Turn ignition off. Insert proper EPROM memory card into New Generation Star (NGS) tester. Attach OBD-II (16-pin) data cable to NGS tester.
- Connect OBD-II data cable to OBD-II data link connector located under left side of instrument panel. See Fig 2. Plug power cable into cigarette lighter. Turn ignition on. If serial communication is okay, go to QUICK TEST . If a serial communication error exists, see COMMUNICATION ERROR .